3-134
GZ359
2. Noting the reference dots on the gerotor set, sepa-
rate the inner rotor from the outer rotor and with
the reference dot directed toward the oil pump
cover, place the rotor on the shaft; then install the
drive pin and push the shaft into the rotor.
GZ356
GZ363
3. With the outer rotor reference dot directed toward
the oil pump cover, install the rotor onto the inner
rotor.
GZ360
4. Place a new O-ring seal on the outside of the oil
pump cover. The oil pump assembly is now ready
for assembly into the crankcase.
GZ362
CRANKSHAFT ASSEMBLY
NOTE: The crankshaft and connecting rod is a
non-serviceable assembly. If any component is
out of specification, the assembly must be
replaced.
Measuring Connecting Rod
(Small End Inside Diameter)
1. Insert a snap gauge into the upper connecting rod
small end bore; then remove the gauge and mea-
sure it with micrometer.
CC290D
2. Maximum diameter must not exceed specifica-
tions.
Next
Back
Section
Table of Contents
Manual
Table of Contents
