3-113
3
27. Install the cylinder head plugs in the cylinder
heads with the open end facing downward and
toward the inside.
CD468
28. Remove the cap screw from the end of the chain
tensioner; then using a flat-blade screwdriver,
rotate the adjuster screw inside the tensioner
clockwise until the screw bottoms.
CD501
NOTE: The adjuster shaft will be drawn into the
tensioner as the adjuster screw is rotated clock-
wise. The adjuster shaft tension will be released in
step 30.
29. Place the chain tensioner adjuster assembly and
gasket into position on the cylinder and secure
with the two cap screws.
CD469
30. Using a flat-blade screwdriver, rotate the adjuster
screw inside the tensioner counterclockwise until
all tension is released; then install the cap screw
into the end of the chain tensioner.
GZ201
CD471
31. Loosen the four adjuster screw jam nuts; then
loosen the four adjuster screws on the rocker arms
in the valve cover.
GZ199
32. Apply a thin coat of Three Bond Sealant to the
mating surfaces of the cylinder heads.
CAUTION
The open end of the plug must be positioned downward.
Next
Back
Section
Table of Contents
Manual
Table of Contents
