3-27
3
9. Remove the shift detent cam.
10. Remove the cam stopper assembly.
11. Remove two starter motor cap screws.
KC217
12. Remove starter motor by tapping lightly with a
mallet.
NOTE: The starter motor is a non-serviceable
component and must be replaced as an assembly.
13. Using an impact screwdriver, remove the three
Phillips-head screws holding the crankshaft bear-
ing retainer. Remove the crankshaft bearing
retainer.
MD1122
Installing Left-Side
Components
A. Starter Idler Gears
B. Rotor/Flywheel
1. Place the crankshaft bearing retainer into position.
Apply red Loctite #271 to the three cap screws.
Install and tighten the three cap screws securely.
MD1122
2. Install the starter motor and tighten the two cap
screws securely.
3. Install the shift detent cam making sure the washer
is installed.
MD1086
4. Install the cam stopper assembly.
5. Install the gear shift shaft assembly and washer
making sure to align the alignment marks.
MD1239
6. Install starter idler gear (No. 2) and starter idler
gear (No. 1).
Next
Back
Section
Table of Contents
Manual
Table of Contents
