3-144
GZ265
9. Carefully place the lower crankcase cover onto the
joined crankcase halves; then secure with the cap
screws. Tighten the 6 mm cap screws to 8 ft-lb and
the 8 mm cap screws to 20 ft-lb.
GZ321
10. Install the oil screen; then apply a thin bead of sili-
cone sealant to the oil strainer cap and secure with
the cap screws. Tighten to 8 ft-lb.
Joining Crankcase
Halves
(Gen. II)
1. Using rubber bands, support the connecting rods to
align with the cylinder bores.
GZ340
2. Coat both sides with motor oil; then install the
spacer washer on the crankshaft with the radius
directed toward the crankshaft.
GZ341
3. Install the two alignment pins; then apply a thin
bead of silicone sealant to the crankcase mating
surface.
GZ345A
4. Carefully join the crankcase halves by placing the
left-side crankcase onto the assembled right side.
Secure with the cap screws (eight left side and one
right side).
AT THIS POINT
After completing center crankcase components, pro-
ceed to Installing Right-Side Components, to Install-
ing Left-Side Components, and to Installing Top-Side
Components.
Next
Back
Section
Table of Contents
Manual
Table of Contents
