3-127
3
GZ446
2. Remove the cap screws securing the lower crank-
case to the upper crankcase halves; then using a
rubber hammer, free the lower crankcase and
remove. Account for two alignment pins.
GZ447
3. Remove the secondary drive assembly; then
remove the secondary driven shaft assembly and
set aside. Account for one locating ring.
GZ448A
GZ269A
NOTE: Do not disassemble these assemblies
unless service is required. If disassembled, sec-
ondary gear sets will have to be reset for backlash
and gear contact (see Servicing Center Crankcase
Components in this section).
4. Remove one cap screw from the right-side crank-
case and eight cap screws from the left-side crank-
case; then using a rubber mallet, separate the
crankcase halves leaving all components in the
right-side case. Account for a thrust washer on the
crankshaft and flat washers on gear shift shaft,
countershaft, and reverse idler. Note the location
of two alignment pins.
GZ454A
GZ272B
Next
Back
Section
Table of Contents
Manual
Table of Contents
