4-9
4
10. Remove the cap screws securing the intake pipe to
the cylinder head and remove the throttle body
assembly; then remove the intake pipe from the
throttle body. Account for an O-ring.
FI104A
11. Use tape to cover and seal the intake opening.
REMOVING (H2)
1. Remove the front rack and body panel (see Section
8).
2. Disconnect the wires from the IAT sensor; then
loosen the clamp and remove the inlet air boot
from the air filter housing.
GZ379
GZ091A
3. Loosen the clamp on the throttle body intake boot;
then remove the air filter housing from the ATV.
4. Disconnect the three wiring connectors from the
sensors on the throttle body; then remove the cap
screws securing the throttle body to the intake
manifold.
GZ094B
GZ381A
5. Remove the throttle arm cover and disconnect the
throttle cable; then remove the throttle body from
the ATV.
CAUTION
Any objects or liquid entering the intake opening will
fall into the engine causing severe damage if the
engine is turned over or started.
! WARNING
Whenever the gasline hoses are removed (other than
for pressure testing), the battery must be discon-
nected to prevent inadvertent activation of the elec-
tronic fuel pump.
Next
Back
Section
Table of Contents
Manual
Table of Contents
