2-16
GZ085
INSTALLING
1. Place the V-belt into position on the driven pulley
and over the front shaft.
GZ085
NOTE: The arrows on the V-belt should point in
direction of engine rotation (forward).
2. Pinch the V-belt together near its center and slide
the spacer and movable drive face onto the drive-
shaft. Secure the drive face with a washer and nut
(coated with red Loctite #271). Tighten the nut to
147 ft-lb (400) or 165 ft-lb (H1/H2).
GZ485A
NOTE: At this point, the push-bolt can be
removed.
3. Rotate the V-belt and clutches until the V-belt is
flush with the top of the driven clutch.
4. Place the V-belt cover gasket into position; then
install the cover and secure with the cap screws
making sure the different-lengthed cap screws are
in their proper location. Tighten the cap screws to
8 ft-lb.
CD083
NOTE: Make sure the main engine ground wire is
installed and secured in the proper location.
5. Install the right-side footrest (see Section 8).
6. Secure the front fender to the footrest with the two
cap screws. Tighten securely.
CAUTION
Make sure the movable drive face plate is fully
engaged onto the splines of the clutch shaft before
torquing the nut or false torque readings may occur.
This will cause the assembly to loosen damaging the
shaft and clutch face plate.
Back
Section
Table of Contents
Manual
Table of Contents
