4-6
CC749
7. Place the U-ring into the pump housing. Position
the spring and diaphragm assembly (lip toward the
carburetor) onto the carburetor; then secure the
assembly with the pump housing and three screws.
Tighten securely.
CC748
8. Place the jet needle, spring seat, and spring into
the vacuum piston; then place the assembly down
into the carburetor.
CC746
9. Place the top cover into position; then secure with
the Phillips-head screws. Tighten securely.
CH015D
INSTALLING
1. Connect the gas and vent hoses onto the carbure-
tor.
2. Connect the electric choke lead to the wiring har-
ness.
CC740A
3. Place the throttle cable into position and secure by
tightening the outer jam nut.
PR162B
4. Connect the throttle cable to the actuator arm.
CAUTION
It is important to press down on the pump housing
until it contacts the carburetor to make sure the dia-
phragm lip is properly seated in the groove in the car-
buretor. If the diaphragm is not properly seated,
leakage will occur.
Next
Back
Section
Table of Contents
Manual
Table of Contents
