3-42
MD1199
MD1079
2. Install and tighten the output shaft flange nut to 59
ft-lb. Using a punch, peen the nut.
MD1333
3. Apply a liberal amount of oil to the crankshaft
bearing. Using a propane torch, heat the bearing
until the oil begins to smoke; then slide the crank-
shaft assembly into place.
MD1334
NOTE: If heating the bearing is not possible, the
crankshaft can be installed using a crankshaft
installer.
4. Rotate the crankshaft so the counterweight is
toward the rear of the engine. Install the counter-
balance shaft.
MD1024
5. Keeping the counterbalance gear timing mark
aligned with the one on the crankshaft gear, install
the key and the counterbalance gear.
CD826A
6. Keeping the slot directed as shown, install the shift
cam and inner and outer washers.
KC325
7. Align the inner shift fork with the gear cluster and
with the inner washer in place, install the gear
cluster and inner shift fork. While holding the gear
cluster in place, install the washer, gear, and snap
ring.
Next
Back
Section
Table of Contents
Manual
Table of Contents
