3-140
8. Place two flat washers on the drive gear end of the
countershaft and one flat washer on the high
driven gear end; then with shift forks and shift fork
shaft, install the countershaft assembly into the
crankcase.
GZ280A
GZ336
9. Engage the shift forks into the gear shift shaft and
push the shift fork shaft into the crankcase.
GZ339
Assembling Crankcase
Half
(Gen. II)
1. Install the oil pump gerotor assembly and oil pump
cover in the crankcase and secure with two cap
screws. Coat the threads with blue Loctite #243
and tighten securely to 8 ft-lb.
GZ305
2. Install a flat washer, drive pin, and drive gear onto
the oil pump shaft; then secure with a snap ring
(flat-side away from the gear).
GZ347
3. Install the countershaft into the crankcase and
secure with the snap ring (flat side away from the
bearing).
GZ463A
AT THIS POINT
Proper transmission shifting should be verified by
turning the gear shift shaft to select High, Low, Neu-
tral, and Reverse while rotating the input shaft and
observing the countershaft rotation.
AT THIS POINT
The right-side crankcase is now ready for installation
to the left-side crankcase. Proceed to Joining Crank-
case Halves (Gen. I).
Next
Back
Section
Table of Contents
Manual
Table of Contents
