3-71
3
15. Remove the gear shift cam plate; then remove the
cam stopper and cam stopper spring. Account for
two washers.
PR434A
Installing Left-Side
Components
NOTE: Plug the oil passage in the crankcase
housing prior to installing the drive gear/driven
gear assembly to prevent loss of an alignment pin.
1. Install the water pump driven gear alignment pin
and the driven gear (with the beveled side of the
gear facing outward as noted in removing); then
secure with the snap ring.
CD950A
CD952A
CD949
NOTE: The sharp side of the snap ring should be
facing outward.
2. Install the water pump drive gear drive pin and the
drive gear (with the flat side of the gear facing out-
ward as noted in removing); then secure with the
snap ring.
CD946A
CD944
NOTE: The sharp side of the snap ring should be
facing outward.
NOTE: Once the gears are secured, remove the
oil passage plug from the crankcase.
3. Install the two starter gear shafts; then install the
two starter gears (with the beveled side of the
intermediate gear facing inward as noted in
removing).
Next
Back
Section
Table of Contents
Manual
Table of Contents
