3-128
Disassembling
Crankcase Half
(Gen. I)
NOTE: For steps 1-8, refer to illustration GZ298A.
GZ298A
NOTE: To aid in installing, it is recommended that
the assemblies are kept together and IN ORDER.
1. Support the right-side crankcase assembly on suit-
able support blocks; then carefully remove the
crankshaft assembly (A) from the crankcase.
GZ298
2. Remove the snap ring securing the water pump
drive idler (B) to the idler shaft; then remove the
drive idler.
GZ299A
3. Remove the water pump driven shaft (C). Account
for the driven gear and drive pin.
GZ304A
4. Remove the snap ring securing the oil pump
driven gear (D) to the oil pump driveshaft; then
remove the gear. Account for a drive pin and
washer.
GZ301A
5. Remove the shift fork shaft (E); then remove the
gear shift shaft assembly (F). Account for three
flat washers.
GZ276
6. Remove two cap screws securing the oil pump in
the crankcase and remove the oil pump.
Next
Back
Section
Table of Contents
Manual
Table of Contents
