8-17
8
Side Storage Box
(TBX)
REMOVING
1. Rotate the cargo box latch handle (located on
the left and right sides between the cargo box
and the rear tire) and fully raise the cargo box.
2. Pull the seat lock lever forward (located below
the right side of the seat), raise the front end of
the seat, and slide it forward and off the ATV.
3. Remove the two cap screws (located inside the
side storage box) securing the box to the foot-
rest.
4. Remove the screw securing the box to the side
panel.
5. Remove cap screws (A and B) securing the box
to the frame.
CD045A
CLEANING AND INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Clean all side storage box components with soap
and water.
2. Inspect the box for cracks, tears, and loose
mounting hardware.
3. Inspect the box hatch O-ring seals for cuts or
tears.
INSTALLING
1. Place the side storage box into position on the
frame; then secure with the two cap screws (A
and B). Tighten cap screws to specifications.
CD045A
2. Secure the box to the side panel with the exist-
ing screw.
3. Secure the box to the footrest with existing hard-
ware. Tighten securely.
4. Install the seat.
5. Lower the cargo box and press down firmly on
the front of the box. The cargo box will automat-
ically lock into position.
Cargo Box
(TBX)
REMOVING
1. Rotate the cargo box latch handle (located on
the left and right sides between the cargo box
and the rear tire) and fully raise the cargo box.
CD771
2. Remove the nut from the lower end of the box
lift support.
3. Remove the two cap screws and lock nuts secur-
ing the cargo box to the frame; then remove the
cargo box and discard the lock nuts.
Next
Back
Section
Table of Contents
Manual
Table of Contents
