Raritan EMX2-111, Руководство пользователя

Страница: 32 / 565

Chapter 3: Initial Installation and Configuration
20
To verify network settings:
After exiting the above configuration mode and the # prompt re-appears,
type this command to verify all network settings.

show network
The IP address configured may take seconds to take effect.
Bulk Configuration Methods
If you have to set up multiple EMX devices, you can use one of the
following configuration methods to save your time.
Use a bulk configuration file:

Requirement: All EMX devices to configure are of the same model
and firmware.

Procedure: First finish configuring one EMX. Then save the bulk
configuration file from it and copy this file to all of the other EMX
devices.
See
Bulk Configuration
(on page 272).
Use a TFTP server:

Requirement: DHCP is enabled in your network and a TFTP server is
available.

Procedure: Prepare special configuration files, which must include
fwupdate.cfg, and copy them to the root directory of the TFTP server.
Re-boot all EMX after connecting them to the network.
See Bulk Configuration or Firmware Upgrade via DHCP/TFTP (on
page 442).
Use a USB flash drive:

Requirement: A FAT32- or supperfloppy-formatted USB flash drive
containing special configuration files is required.

Procedure: Plug this USB drive into the EMX. When a happy smiley is
shown on the front panel display, press and hold one of the control
buttons on the front panel until the display turns blank.
See
Configuration or Firmware Upgrade with a USB Drive
(on
page 430).