Raritan EMX2-111, Руководство пользователя

Страница: 217 / 565

Chapter 6: Using the Web Interface
205
To create a scheduled action:
1. If the needed action is not available yet, create it by clicking
. See above.
Note: When creating scheduled actions, available actions are less
than usual because it is meaningless to schedule certain actions like
"Alarm," "Log event message," "Send email," "Syslog message" and
the like.
2. Click to schedule the desired
action.
a. Assign a name to this scheduled action.
b. Make sure the Enabled checkbox is selected, or the EMX does
not perform this scheduled action.
c. Set the interval time, which ranges from every minute to yearly.
d. In the Available Actions field, select the desired action(s).
e. Click Create.
For details, see
Scheduling an Action
(on page 235).
Built-in Rules and Rule Configuration
The EMX is shipped with four built-in event rules, which cannot be
deleted. If the built-in event rules do not satisfy your needs, create new
rules.
Built-in rules:

System Event Log Rule:
This causes ANY event occurred to the EMX to be recorded in the
internal log. It is enabled by default.
Note: For the default log messages generated for each event, see
Default Log Messages
(on page 210).

System SNMP Notification Rule:
This causes SNMP traps or informs to be sent to specified IP
addresses or hosts when ANY event occurs to the EMX. It is disabled
by default.

System Tamper Detection Alarmed:
This causes the EMX to send alarm notifications if a DX tamper
sensor has been connected and the EMX detects that the tamper
sensor enters the alarmed state. It is enabled by default.