Mitsubishi Electric EZMotion-NC E60 Series, Руководство по эксплуатации

Страница: 157 / 510

4. Parameters (User)
4.1 Workpiece Coordinate
I -142
Return the sensor to the reference
point, and turn OFF the
measurement switch.
9)
The message " WLM " disappears.
(4) Subtracting external workpiece offset when workpiece coordinate offset is set
When workpiece coordinate G54 to G59, offset of expend workpiece coordinate offset P101 to
P148 are set ([INPUT]) in the surface, hole center and width center workpiece offset
measurement, the coordinate value that subtracted external workpiece offset value from the
measurement position coordinate (or hole, width center coordinate) is set.
When "External workpiece offset" (#1237 set09/bit0) is OFF
The workpiece coordinate offset = The measurement (center) coordinate value - The external workpiece offset
When "External work offset" (#1237 set09/bit0) is ON
The workpiece coordinate offset = The measurement (center) coordinate value + The external workpiece offset
(5) Automatic re-contact movements at the time of contact
When the measurement is performed during jog mode or handle mode, perform following
operation after contact.
Move to the measurement point in
jog mode.
1)
Stop on the measurement point.
2)
skip
Return by the return amount of
measurement parameter (#8705).
3)
Return
amount
Move to the measurement point
again by feed rate of measurement
parameter (#8706).
4)
Stop on the measurement point.
(Readout of skip coordinates)
5)
skip