Mitsubishi Electric EZMotion-NC E60 Series, Руководство по эксплуатации

Страница: 67 / 510

2. Monitor
2.4 PROGRAM SEARCH
I -52
(2) Canceling compare stop
Press the
INPUT
key.
The program number, sequence
number and block number settings as
well as the "COLL. EXEC" message
are cleared.
Set 0 in COL. ( ).
O ( ) N ( ) - ( )
COL. ( 0 ) TAPE ( )
O ( ) N ( ) - ( ) COL. ( 0) TAPE ( )
[COLLATION BLOCK] COLL. EXEC
O 1234 N 20 - 3
O ( ) N ( ) - ( ) COL. ( 0) TAPE ( )
[COLLATION BLOCK]
O N -
(3) Precautions
1) When there are several identical sequence numbers and block numbers in a program,
compare stop results after the first corresponding block in the sequence of execution has
been executed.
2) The compare stop setting is canceled in the following cases.
•
When compare stop has been performed
•
When "0" has been set in the "COL. ( )" on the SEARCH screen
•
When the reset mode has been established
3) If only the program number is set, compare stop will take place at the head of the program
only when there is a program number at the first line.
4) When the program and sequence numbers have been set and the block number has not
been set, the block number is considered to be "0".
5) Compare stop cannot be performed for blocks being executed or blocks already read into the
preread buffer. (Compare stop can be set.)
6) Compare stop cannot be canceled if the block in which compare stop is set is being executed
or has already been read into the preread buffer. (Cancellation of compare stop can be set.)
7) Even if a block not included in the execution program is assigned, no check is conducted to
verify whether it exists in the program.
8) Compare stop is not performed in the tapping mode.
9) Compare stop is possible in a subprogram, but is not possible in a machine maker macro
program.
10) If compare stop is set for a fixed cycle block, compare stop will be executed after the
positioning block is completed.
11) Compare stop is possible while the program display is locked (compare stop in an address
9000 program).
12) If compare stop is set for M98 subprogram call, compare stop will be executed at the M98
block.
13) If compare stop is set for M198 subprogram call, compare stop will be executed at the M198
block.