Mitsubishi Electric EZMotion-NC E60 Series, Руководство по эксплуатации

Страница: 235 / 510

6. Data In/Out
6.1 DATA INPUT
I
-220
6.1.2 Machining Program Input
To input a user-prepared machining program, perform the following:
(1) When inputting the program number stored in the external memory device.
The program can be input simply by specifying machining program data type #1. If the program
number is specified, the number stored in the external memory device takes precedence over
that number.
1) Data input is started.
The program number being
entered is displayed in the setting
area.
2) When normal data input is
executed to the end and the EOR
code is read, data input is
terminated.
Press the
INPUT
key.
Set the data type.
# ( 1 ) DATA ( )
# ( 1 ) DATA ( )
<INPUT DATA>
O1234 (TEST-PRO.#1) ;
<COMP. DATA>
DATA IN EXECUTION
# ( 1 ) DATA ( 1234)
<INPUT DATA>
%
<COMP. DATA>
DATA IN COMPLETE
# ( ) DATA ( )
E E E E E E
O O O 1234(TEST-PRO,#1) O N1G28 X0 Y0 Z0 O N2 M02 O O
R B B B B R
Program main unit Program number and comment
CAUTION
";" "EOB" and "%" "EOR" are expressions used for explanation. Under ISO, the actual codes
are "CR, LF" or "LF" for ";" "EOB" and "%" for "%" "EOR".
Programs created on the Edit screen are stored in the NC memory in a "CR, LF" format, but
programs created with external devices may be stored in an "LF" format.
The actual codes for EIA are: "EOB (End of Block)" and "EOR (End of Record)".
To prevent influence from data omission and data transformation in the communication
circuit, always verify the data after inputting and outputting machining programs.