Mitsubishi Electric EZMotion-NC E60 Series, Руководство по эксплуатации

Страница: 237 / 510

6. Data In/Out
6.1 DATA INPUT
I
-222
6.1.3 Inputting Tool Offset Data
Data which is output by tool offset data output operation can be input.
Data which is created in the same format as output data can be input as tool offset data and workpiece
coordinate offset data.
(Note) Tool offset data input operation cannot be made during automatic operation.
(1) Inputting tool offset data
Set the data type to tool data.
# ( 2 ) DATA ( )
# ( 2 ) DATA ( )
1) Data input is started. The contents of input data
and message "DATA IN EXECUTION" are
displayed.
2) When all data has been input to the end and the
end code % (EOR) is read, data input ends with
message "DATA IN COMPLETE" displayed.
Press the
INPUT
key.
<INPUT DATA>
G10 L10 P···;
<COMP. DATA>
DATA IN EXECUTION
# ( 2 ) DATA ( )
<INPUT DATA>
%
<COMP. DATA>
DATA IN COMPLETE
# ( ) DATA ( )
(2) When an error occurs during offset data input:
If an error occurs during offset tape input, the error number and error message will be displayed
on the screen. At this time, input operation stops. (E02, E25, E71, or E86 error)
In this case, data input can resume by repressing the
INPUT
key while the input screen is being
displayed. The data input can resume, beginning with the block next to the erroneous block,
which is not input in this case.