6. Data In/Out
6.3 PROGRAM ERASE
I
-245
(3) To erase all machining programs registered in memory
To erase all of machining programs 1~99999999 registered in memory, perform the following:
# ( ) DATA ( CLR )
ERASE
COMPLETE
# ( ) DATA ( )
Press the
INPUT
key.
Set "CLR" in DATA ( ).
# ( )
DATA ( C L R )
ERASE
EXECUTION
# ( ) DATA ( CLR )
PROGRAM ENTRY
0
REMAIN
200
CHARACTER 0
REMAIN
64000
<PROGRAM> <CHR>
<ST>
<COMMENT>
Check the PROGRAM FILE screen.
1) All machining program erase is
executed and terminated almost in a
moment. The message "ERASE
COMPLETE" is displayed in the
message field and the data setting
area becomes blank.
1) "PROGRAM ENTRY" is set to 0 and "REMAIN" is
set to the maximum number of programs defined in
the specifications.
2) "CHARACTER" is set to 0 and "REMAIN" is set to
the maximum number of stored characters defined
in the specifications.
The number of programs and the number of
characters are as listed below according to the
specifications:
Tape storage
length
Number of
programs
Number of
characters
Remarks
160m 200 64000
E60 Ver.A only
600m 400
236250
3) The PROGRAM FILE screen becomes blank,
indicating that no programs are registered.
1) No value needs to be entered in #
( ).
Содержание EZMotion-NC E60 Series
