Mitsubishi Electric EZMotion-NC E60 Series, Руководство по эксплуатации

Страница: 37 / 510

2. Monitor
2.1 POSITION
I -22
2.1.3 Manual Numeric Command (S, T, M)
You can easily execute spindle function S, tool function T and miscellaneous function M by operation
on the screen. Namely, you can key in S, T and M commands as if they were commanded by a
program.
(1) Conditions that allow manual numeric command
M, S or T command sequence is not under way. Even during automatic start or pause, for
example, the manual numeric command is available if above conditions are met.
(2) Operating procedures of manual numeric commands
1) Select the position display
POSI
menu screen.
2) Press the address key corresponding to the command. This causes the corresponding
commanded value display section to be highlighted and makes the system ready for input of
manual numeric command. The spindle function key is
S
, tool function key is
T
and
miscellaneous function key is
M
.
3) Key-in the numerical value to be input.
4) Press the
INPUT
key.
(Example) The procedures to execute S1200 by manual numeric command are given below. First
select POSITION display on MONITOR screen.
On screen, last executed command
value is displayed.
Press the address key
S
.
1) The address corresponding to the
pressed key and numerical value
setting range are highlighted.
S 500
S
Set the numerical value by number
keys.
1 2 0 0
1) The set numbers are displayed
successively as highlighted.
S 1200
Press the
INPUT
key.
1) The S command is executed.
2) The reversed display on screen
returns to normal.
S 1200