Mitsubishi Electric EZMotion-NC E60 Series, Руководство по эксплуатации

Страница: 71 / 510

2. Monitor
2.5 Resuming the Program
I -56
(2) Restart type 2
When a machining program, which differs from the machining program to be restarted, has been
operated in the memory or tape mode prior to the restart search of the machining program to be
restarted, and when the coordinate systems applying during the previous automatic operation
and the systems applying during machining restart are to be changed.
The operating sequence for type 2 is the same as that for type 1 although before the restart
search all the settings of the coordinate systems must be made before the machining program is
operated. The main program to be restarted must be searched for just before executing restart
start.
Operation of
different program
Machining program
Machining
suspended
Machining
restart
It will not be possible to restart machining properly
when the axxes are not located at the positions
applying to program start in cases where the
program head command is an incremental command
or a G92 command.
Operations on PROGRAM RESTART screen
For type A, the program No. cannot be omitted.
For type B, the program No. cannot be input.
Upon completion of the restart search, the M, S, T
and B functions, the restart distance to go and the
restart positions will be displayed.
"RP" is displayed when the axes have finished
moving to the restart position and the subsequent
axes, do not move in either the "+" or "-" direction.
Move the axes to the restart return positions.
(Refer to 2.5.3 Restart Position Return System)
Issue the M, S, T or B manual numerical
command.(Refer to 2.5.4 Manual Numerical
Commands with Program Restart)
Start
Set by MDI the coordinate systems applying
when the restart program is to start.
Search the block from which machining is to
restart using the type 2 method.
(Refer to 2.5.2 Restart Search Operations)
Set the program restart switch to OFF.
Return to the automatic mode.
Turn ON the power and return all the axes to
their reference points.
Move the axes to their program restart positions.
Press the cycle start button.
End
Search the head of the program.
For the tape mode, the head of program should
be searched on the operation screen or IC card
screen.
Set the program restart switch to ON.