Mitsubishi Electric EZMotion-NC E60 Series, Руководство по эксплуатации

Страница: 267 / 510

6. Data In/Out
6.7 Data Protection
I
-252
6.7 Data Protection
6.7.1 Data Protection Key
Data protection keys can inhibit data from being set or erased. There are three types of data
protection keys as shown below (the key names depend on the machine makers. For the details, refer
to the manuals issued by individual machine makers).
1) KEY 1: Protection of all tool data and coordinate system values preset by origin setting
2) KEY 2: Protection of user parameters and common variables
3) KEY 3: Protection of work programs
The data protection keys protect data when they are turned off.
Data setting
screen
KEY1
Tool data
User parameters
Machining programs
Data protection key
Target data
KEY2
KEY3
1) Protection of tool data (KEY 1)
When KEY 1 is OFF, the operation items listed in Table 1 are inhibited.
Table 1 Data protection by KEY 1
No. Operation Screen
1 Origin setting MONITOR/POSITION
2 Setting/erasing of tool nose wear compensation TOOL/COMP TOOL TIP OFFSET
3 Setting/erasing of tool length offset TOOL/COMP TOOL DATA
4
Setting/erasing of nose-R compensation,
wear compensation and tool nose point
TOOL/COMP NOSE-R/P
5 Setting/erasing of tool life data TOOL/COMP TOOL LIFE
6
Setting/erasing of workpiece coordinate offset
data
PARAM/WORK OFFSET
7 Tape input of tool offset data IN/OUT INPUT
8 Tape output of tool offset data IN/OUT OUTPUT
(Note) When key 1 is OFF, no data is input by pressing any key other than the MENU key on the
screens corresponding to numbers 2 to 6 in Table 1. Instead, it will display the message
"DATA PROTECT".
You can't set the origin by pressing the
C.B
CAN
key on the POSITION/COORDINATE
screen. Only the message "DATA PROTECT" will be displayed.
Manual numeric command also cannot be carried out on the TOOL screen.
When an attempt is made to perform the operation of number 7 or and/or 8, you cannot
input or output data through the input key. Instead, the message "DATA PROTECT" will
be displayed.