1. Slide cuff onto arm so that the bottom edge of cuff
is just above the elbow crease. Then position tube
off-center toward the inner side of arm in line with
the little finger
2. Fasten the cuff tight enough so you
can slide two fingers under it.
3. Sit comfortably with arm resting on
a flat surface, palm up.
4. Press START button. (Battery installation required.
Please see manual for instructions.)
5. Your average blood pressure
reading will appear followed
by a zero, indicating that
monitor is ready for mea-
surement.
6. Press the exhaust valve until the
mark is displayed. Squeeze bulb
repeatedly until the mark dis-
appears.
7. Sit quietly during measurement.
8. Your systolic and diastolic pressure and
pulse rate will appear in the digital dis-
play.
9. Press exhaust valve on the bulb to release
remaining air from cuff after measure-
ment is complete.
UA-705 QUICK START CARD
1-888-726-9966
www.LifeSourceOnline.com
LifeSource is a trademark of A&D Medical.
©2008 A&D Medical. All rights reserved. 8/08.
