Keysight Technologies N69100 Series, Руководство по эксплуатации и обслуживанию

Страница: 131 / 260

.
Select the trigger source
A TRIGger:ACQuire[:IMMediate] command over the bus will always generate an
immediate measurement trigger, regardless of the selected trigger source.
Unless you are using TRIGger:ACQuire[:IMMediate], select a trigger source from the following:
Trigger Source Description
Bus Selects GPIB device trigger, *TRG, or <GET> (Group Execute Trigger).
External Selects ANY pin that has been configured as a trigger input on the digital control port.
Pin<1-7> Selects a specific pin<n> that is configured as a Trigger Input on the digital control port.
Transient Selects the unit’s transient system. You must also set up the transient system to generate a trigger out signal.
See
Programming Output Transients .
Use the following commands to select a trigger source:
Front Panel Menu Reference SCPI Command
Not available To select Bus triggers:
TRIG:TRAN:SOUR BUS
To select digital pin 5 as the trigger:
TRIG:ACQ:SOUR PIN5
To select an output transient as trigger:
TRIG:ACQ:SOUR TRAN
Initiate the acquisition system
When the unit is turned on, the trigger system is in the idle state. In this state, the trigger system is
disabled, ignoring all triggers. The INITiate commands enable the trigger system to receive triggers.
Keysight N69100 Series Operating and Service Guide 131
4 Using the DC Power System