Keysight Technologies N69100 Series, Руководство по эксплуатации и обслуживанию

Страница: 96 / 260

Programming the Output
Set the Output Priority Mode
Set the Output Voltageand Low Voltage Limit
Set the Output Current
Set the Slew Rate
Set the Output Resistance
Set the Output Bandwidth
Set the Output Turn-On/Turn-Off Mode
Enable the Output
SHOCK HAZARD, LETHAL VOLTAGES - Some models generate output voltages up
to 2,000 VDC! Ensure that all instrument connections, load wiring, load and sense
connections are insulated using high-voltage wire. Always attach the safety cover
provided, so that no accidental contact with lethal voltages can occur.
When the unit is first turned on, it may take about 30 seconds or so to initialize the
instrument before it is ready for use.
Set the Output Priority Mode
Select either voltage priority or current priority operating mode. Refer to Priority Mode Operation for
more information.
Voltage priority - this mode keeps the output voltage constant. The output voltage remains at its
programmed setting, provided the load current remains within the + or - current limit setting.
Current priority - this mode keeps the output current constant. The output current remains at its
programmed setting, provided the load voltage remains within the voltage limit setting.
Front Panel Menu Reference SCPI Command
Select Output\Mode .
Select Voltage or Current priority. Then press Select .
To specify current or voltage priority mode:
FUNC CURR|VOLT
When switching between modes, the output is turned off and the output settings
revert to their power-on or RST values.
4 Using the DC Power System
96 Keysight N69100 Series Operating and Service Guide