Keysight Technologies N69100 Series, Руководство по эксплуатации и обслуживанию

Страница: 201 / 260

TRIGger Subsystem
Trigger commands control the transient and acquisition subsystems. Refer to Trigger Overview for
more information.
TRIGger:ACQuire[:IMMediate]
TRIGger:TRANsient[:IMMediate]
Generates an immediate trigger. This overrides any selected trigger source.
TRIGger:ACQuire triggers the acquisition system.
TRIGger:TRANsient triggers the transient system.
Parameter Typical Return
(none) (none)
Generate a measurement trigger: TRIG:ACQ
TRIGger:ACQuire:SOURce < source >
TRIGger:ACQuire:SOURce?
Selects the trigger source for the acquisition system:
BUS Selects a remote interface trigger command.
EXTernal Selects ALL digital port pins that have been configured as trigger sources.
PIN<1-7> Selects a digital port pin configured as a trigger input.
TRANsient1 Selects the transient system as the trigger source.
Parameter Typical Return
BUS | EXTernal | PIN<1-7> | TRANsient1 | *RST BUS BUS, EXT, PIN<n>, or TRAN1
Select digital port pin 1 as the measurement trigger source: TRIG:ACQ:SOUR PIN1
TRIGger:ACQuire:TOUTput[:ENABle] 0|OFF|1|ON
TRIGger:ACQuire:TOUTput[:ENABle]?
Enables measurement triggers to be sent to a digital port pin. The digital port pin must be configured
as trigger output before it can be used as a trigger source (see
External Trigger I/O ).
Parameter Typical Return
0|OFF|1|ON, *RST OFF 0 or 1
Enable sending measurement triggers to digital pins: TRIG:ACQ:TOUT ON
Keysight N69100 Series Operating and Service Guide 201
5 SCPI Programming Reference