Dell Networking S4810, Справочное руководство

Страница: 812 / 1761

pre-Version
6.2.1.0 Introduced on E-Series.
Usage
Information
Port Channel interfaces are logical interfaces and can be either in Layer 2 mode (by
using the
switchport
command) or Layer 3 mode (by configuring an IP address).
You can add a Port Channel in Layer 2 mode to a VLAN.
The
shutdown
,
description
, and
name
commands are the only commands that
you can configure on an interface while it is a member of a Port Channel. To add a
physical interface to a Port Channel, the interface can only have the
shutdown
,
description
, and
name
commands configured. The Port Channel’s configuration
is applied to the interfaces within the Port Channel.
A Port Channel can contain both 100/1000 interfaces and GE interfaces. Based on
the first interface configured in the Port Channel and enabled, Dell Networking OS
determines if the Port Channel uses 100 Mb/s or 1000 Mb/s as the common speed.
For more information, refer to
channel-member .
If the line card is in a Jumbo mode chassis, you can also configure the
mtu
and
ip
mtu
commands. The Link MTU and IP MTU values configured on the channel
members must be greater than the Link MTU and IP MTU values configured on the
Port Channel interface.
NOTE: In a Jumbo-enabled system, all members of a Port Channel must be
configured with the same link MTU values and the same IP MTU values.
Example
Dell(conf)#int port-channel 2
Dell(conf-if-po-2)#
Related
Commands
channel-member — adds a physical interface to the LAG.
interface — configures a physical interface.
interface loopback — configures a Loopback interface.
interface null — configures a null interface.
interface vlan — configures a VLAN.
shutdown — disables/enables the port channel.
minimum-links
Configure the minimum number of links in a LAG (Port Channel) that must be in “oper up” status for the
LAG to be also in “oper up” status.
S4810
Syntax
minimum-links number
812
Interfaces