Dell Networking S4810, Справочное руководство

Страница: 338 / 1761

If ACL logging is stopped because the configured threshold is exceeded, it is re-
enabled after the logging interval period elapses. ACL logging is supported for
standard and extended IPv4 ACLs, IPv6 ACLs, and MAC ACLs. You can configure
ACL logging only on ACLs that are applied to ingress interfaces; you cannot enable
logging for ACLs that are associated with egress interfaces.
You can activate flow-based monitoring for a monitoring session by entering the
flow-based enable
command in the Monitor Session mode. When you enable
this capability, traffic with particular flows that are traversing through the ingress
and egress interfaces are examined and, appropriate ACLs can be applied in both
the ingress and egress direction. Flow-based monitoring conserves bandwidth by
monitoring only specified traffic instead all traffic on the interface. This feature is
particularly useful when looking for malicious traffic. It is available for Layer 2 and
Layer 3 ingress and egress traffic. You may specify traffic using standard or
extended access-lists. This mechanism copies all incoming or outgoing packets on
one port and forwards (mirrors) them to another port. The source port is the
monitored port (MD) and the destination port is the monitoring port (MG).
Related
Commands
permit – assigns a permit filter for IP packets.
permit icmp (for IPv6 ACLs)
To allow all or specific internet control message protocol (ICMP) messages, configure a filter.
Syntax
permit icmp { source address mask | any | host ipv6-address }
{ destination address | any | host ipv6-address } [ message-type ]
[count [byte]] [log [interval minutes ] [threshold-in-msgs
[ count ]] [monitor]
To remove this filter, you have two choices:
• Use the
no seq sequence-number
command if you know the filter’s
sequence number.
• Use the
no permit icmp { source address mask | any | host ipv6-
address } { destination address | any | host ipv6-address }
command.
Parameters
log (OPTIONAL) Enter the keyword
log
to enable the triggering
of ACL log messages.
threshold-in
msgs
count
(OPTIONAL) Enter the
threshold-in-msgs
keyword
followed by a value to indicate the maximum number of ACL
logs that can be generated, exceeding which the generation
of ACL logs is terminated with the
seq
,
permit
, or
deny
commands. The threshold range is from 1 to 100.
interval
minutes
(OPTIONAL) Enter the keyword
interval
followed by the
time period in minutes at which ACL logs must be generated.
The interval range is from 1 to 10 minutes.
338
Access Control Lists (ACL)