Dell Networking S4810, Справочное руководство

Страница: 433 / 1761

Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
After you configure a peer group as passive, assign it a subnet using the
neighbor
soft-reconfiguration inbound
command.
For passive eBGP limits, the Remote AS must be different from the AS for this
neighbor.
Related
Commands
neighbor soft-reconfiguration inbound — assigns a subnet to a dynamically
configured BGP neighbor.
neighbor remote-as — assigns an indirectly connected AS to a neighbor or peer
group.
neighbor remote-as
Create and specify the remote peer to the BGP neighbor.
S4810
Syntax
neighbor { ip-address | peer-group-name } remote-as number
To delete a remote AS entry, use the
no neighbor { ip-address | peer-
group-name } remote-as number
command.
Parameters
ip-address Enter the IP address of the neighbor to enter the remote AS
in its routing table.
peer-group-
name Enter the name of the peer group to enter the remote AS
into routing tables of all routers within the peer group.
number Enter a number of the AS. The range is from 0 to 65535 (2
byte) or from 1 to 4294967295 (4 byte).
Defaults Not configured.
Command
Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Border Gateway Protocol
433