Dell Networking S4810, Справочное руководство, Страница: 550 / 1761

set-pgid
Configure the priority-group identifier.
S4810
Syntax
set-pgid value
To remove the priority group, use the
no set-pgid
command.
Parameters
value Enter the priority group identification. The range is from 0 to
7.
Defaults none
Command
Modes PRIORITY-GROUP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0 Introduced on the S4820T.
Version
8.3.12.0 Introduced on the S4810.
Version
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
NOTE: Please note that Dell Networking does not recommended to use this
command as it has been deprecated in the current 9.4.(0.0) release. A warning
message appears when you try to run this command indicating that you have
to use the dcb-map commands in the future.
Related
Commands
• priority-group qos-policy — creates an ETS priority group.
• priority-list — configures the 802.1p priorities.
show interface ets
Displays the ETS configuration applied to egress traffic on an interface, including priority groups with
priorities and bandwidth allocation.
S4810
Syntax
show interface port-type slot/port ets {summary | detail}
550
Data Center Bridging (DCB)