Dell Networking S4810, Справочное руководство

Страница: 753 / 1761

Usage
Information
You cannot delete a Management port.
The Management port is enabled by default (
no shutdown
). To assign an IP
address to the Management port, use the
ip address
command.
If your system has two RPMs installed, use the
show redundancy
command to
display which RPM is the Primary RPM.
Example
Dell(conf)#interface managementethernet 0/0
Dell(conf-if-ma-0/0)#
Related
Commands
management route — configures a static route that points to the Management
interface or a forwarding router.
speed (Management interface) — clears the FIB entries on a specified line card.
interface null
Configure a Null interface on the switch.
S4810
Syntax
interface null number
Parameters
number Enter zero (0) as the Null interface number.
Defaults Not configured; number = 0
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.4.1.0 Introduced
Interfaces
753