Dell Networking S4810, Справочное руководство

Страница: 450 / 1761

Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information At least one interface must be in Layer 3 mode for the
router bgp
command to
be accepted. If no interfaces are enabled for Layer 3, an error message appears:
% Error: No router id
configured
BGP does not allow 23456 (AS-TRANS) as a configured AS number.
Example
Dell(conf)#router bgp 3
Dell(conf-router_bgp)#
show capture bgp-pdu neighbor
Display BGP packet capture information for an IPv4 address on the system.
S4810
Syntax
show capture bgp-pdu neighbor ipv4-address
Parameters
ipv4-address Enter the IPv4 address (in dotted decimal format) of the BGP
address to display packet information for that address.
Command
Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.5.1.0 Introduced.
450
Border Gateway Protocol