Dell Networking S4810, Справочное руководство

Страница: 1350 / 1761

Command
Modes CONFIGURATION (policy-map-input and policy-map-output; conf-qos-policy-in
and conf-qos-policy-out; wred)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
pre-Version
7.7.1.0 Introduced.
Related
Commands
policy-map-input — creates an input policy map.
policy-map-output — creates an output policy map.
qos-policy-input — creates an input QoS-policy on the router.
qos-policy-output — creates an output QoS-policy on the router.
wred-profile — creates a WRED profile.
match ip access-group
Configure match criteria for a class map, based on the access control list (ACL).
S4810
Syntax
match ip access-group access-group-name [set-ip-dscp value ]
To remove ACL match criteria from a class map, use the
no match ip access-
group access-group-name [set-ip-dscp value]
command.
Parameters
access-group-
name Enter the ACL name whose contents are used as the match
criteria in determining if packets belong to the class the
class-map specifies.
set-ip-dscp
value
(OPTIONAL) Enter the keywords
set-ip-dscp
then the IP
DSCP value. The matched traffic is marked with the DSCP
value. The range is from 0 to 63.
Defaults none
Command
Modes CLASS-MAP CONFIGURATION (config-class-map)
1350
Quality of Service (QoS)