Dell Networking S4810, Справочное руководство

Страница: 1524 / 1761

NOTE: The VRF configured using this command has a
higher precedence than the VRF configured using the
ip
ssh vrf vrf-name
command. If you do not configure
a VRF using this command, then the SSH client uses the
configured VRF (if any). If there is a mismatch between
VRFs that are configured using the
ip ssh source-
interface
command and the
ssh vrf vrf-name
command, then an error is reported.
hostname (OPTIONAL) Enter the IP address or the host name of the
remote device.
vrf instance (OPTIONAL) E-Series Only: Enter the keyword
vrf
then the
VRF Instance name to open an SSH connection to that
instance.
ipv4 address (OPTIONAL) Enter the IP address in dotted decimal format
A.B.C.D.
ipv6-address
prefix-length (OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format
then the prefix length in the /x format. The range is from /0
to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
-c encryption
cipher
Enter the following encryption cipher. (For v2 clients only.):
•
3des-cbc
: Force ssh to use 3des-cbc encryption cipher.
-l username (OPTIONAL) Enter the keyword
-l
then the user name used
in this SSH session. The default is the user name of the user
associated with the terminal.
-m HMAC
algorithm
Enter one of the following HMAC algorithms to use. (For v2
clients only.):
•
hmac-sha1
: Force ssh to use the hmac-sha1 HMAC
algorithm.
•
hmac-sha1-96
: Force ssh to use the hmac-sha1-96
HMAC algorithm.
•
hmac-md5
: Force ssh to use the hmac-md5 HMAC
algorithm.
•
hmac-md5-96
: Force ssh to use the hmac-md5-96
HMAC algorithm.
-p port-
number
(OPTIONAL) Enter the keyword
-p
then the port number.
The range is from 1 to 65536. The default is 22 .
-v {1 | 2} (OPTIONAL) Enter the keyword
-v
then the SSH version 1 or
2. The default is the version from the protocol negotiation.
Defaults As shown in the Parameters section.
1524
Security