Dell Networking S4810, Справочное руководство

Страница: 1117 / 1761

ip msdp peer
Configure an MSDP peer.
S4810
Syntax
ip msdp peer peer address [connect-source] [description] [sa-
limit number ]
To remove the MSDP peer, use the
no ip msdp peer peer address
[connect-source interface] [description name ] [sa-limit number ]
command.
Parameters
peer address Enter the peer address in a dotted decimal format (A.B.C.D.).
connect-
source
interface
Enter the keywords
connect-source
then one of the
interfaces and slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet
then the slot/ port information.
• For a Loopback interface, enter the keyword
loopback
then a number from 0 to 16383.
• For a Port Channel interface, enter the keywords
port-
channel
then a number. The range is from 1 to 128.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
• For a VLAN, enter the keyword
vlan
then a number from
1 to 4094.
description
name (OPTIONAL) Enter the keyword description then a
description name (maximum 80 characters) to designate a
description for the MSDP peer.
sa-limit
number
(OPTIONAL) Enter the maximum number of SA entries in SA-
cache. The range is from 1 to 500000. The default it
500000 .
Defaults As described in the Parameters section.
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Multicast Source Discovery Protocol (MSDP)
1117