Dell Networking S4810, Справочное руководство

Страница: 546 / 1761

Version
8.3.19.0 Introduced on the S4820T.
Version
8.3.12.0 Introduced on the S4810.
Version
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
NOTE: Please note that Dell Networking does not recommended to use this
command as it has been deprecated in the current 9.4.(0.0) release. A warning
message appears when you try to run this command indicating that you have
to use the dcb-map commands in the future.
A priority group consists of 802.1p priority values that are grouped for similar
bandwidth allocation and scheduling, and that share latency and loss requirements.
All 802.1p priorities mapped to the same queue must be in the same priority group.
You must configure 802.1p priorities in priority groups associated with an ETS
output policy. You can assign each dot1p priority to only one priority group.
The maximum number of priority groups supported in ETS output policies on an
interface is equal to the number of data queues (4) on the port. The 802.1p
priorities in a priority group can map to multiple queues.
If you configure more than one priority queue as strict priority or more than one
priority group as strict priority, the higher numbered priority queue is given
preference when scheduling data traffic.
You must fully define the priority-group profile with a PGID and priorities before
mapping it to a QoS policy because the PGID and priorities are unique keys of the
traffic class group (TCG) that define the QoS policy.
You must disable the DCB output policy before changing the PGID or priorities of a
priority group assigned to that DCB output policy.
Related
Commands
• priority-list — configures the 802.1p priorities for an ETS output policy.
• set-pgid — configures the priority-group.
priority-group qos-policy
Associate the 802.1p priority traffic in a priority group with the ETS configuration in a QoS output policy.
S4810
Syntax
priority-group group-name qos-policy ets-policy-name
To remove the 802.1p priority group, use the
no priority-group qos-policy
command.
546
Data Center Bridging (DCB)