Dell Networking S4810, Справочное руководство

Страница: 1345 / 1761

Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Usage
Information
To honor all incoming 802.1p markings on incoming switched traffic on the
interface, enter this command. By default, this facility is not enabled (that is, the
802.1p markings on incoming traffic are not honored).
You can apply this command on both physical interfaces and port channels. When
you set the service-class dynamic for a port channel, the physical interfaces
assigned to the port channel are automatically configured; you cannot assign the
service-class dynamic
command to individual interfaces in a port channel.
• All dot1p traffic is mapped to Queue 0 unless you enable the
service-class
dynamic dot1p
command on an interface or globally.
• Layer 2 or Layer 3 service policies supersede dot1p service classes.
strict-priority queue
Configure a unicast queue as a strict-priority (SP) queue.
S4810
Syntax
strict-priority queue unicast number
Parameters
unicast number Enter the keyword
unicast
then the queue number. The
range is from 1 to 7.
Defaults none
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Quality of Service (QoS)
1345