Dell Networking S4810, Справочное руководство

Страница: 755 / 1761

Defaults none
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.2.1.0 Added support for 4093 VLANs on E-Series ExaScale. Prior
releases supported 2094.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0 Introduced on the E-Series.
Usage
Information When creating an interface range, interfaces appear in the order they are entered;
they are not sorted. The command verifies that interfaces are present (physical) or
configured (logical).
Important Points to Remember:
• Bulk configuration is created if at least one interface is valid.
• Non-existing interfaces are excluded from the bulk configuration with a
warning message.
• The
interface range
prompt includes interface types with slot/port
information for valid interfaces. The prompt allows for a maximum of 32
characters. If the bulk configuration exceeds 32 characters, it is represented by
an ellipsis ( ... ).
• When the
interface range
prompt has multiple port ranges, the smaller port
range is excluded from the prompt.
• If overlapping port ranges are specified, the port range is extended to the
smallest start port and the biggest end port.
Example (Bulk)
Dell(conf)#interface range so 2/0-1, te 10/0, gi 3/0, fa 0/0
% Warning: Non-existing ports (not configured) are ignored by
interface-range
Interfaces
755