Dell Networking S4810, Справочное руководство

Страница: 243 / 1761

Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
When all sequence numbers have been exhausted, this feature permits re-
assigning a new sequence number to entries of an existing access-list.
seq
Assign a sequence number to a deny or permit filter in an extended IP access list while creating the filter.
S4810
Syntax
seq sequence-number {deny | permit} { ip-protocol-number | icmp
| ip | tcp | udp} { source mask | any | host ip-address }
{ destination mask | any | host ip-address } [ operator port
[ port ]] [count [byte] | log] [dscp value ] [order] [monitor]
[fragments]
Parameters
sequence-
number Enter a number from 0 to 4294967290. For the S4810 , the
range is from 0 to 65534.
deny Enter the keyword
deny
to configure a filter to drop packets
meeting this condition.
permit Enter the keyword
permit
to configure a filter to forward
packets meeting this criteria.
ip-protocol-
number Enter a number from 0 to 255 to filter based on the protocol
identified in the IP protocol header.
icmp Enter the keyword
icmp
to configure an ICMP access list
filter.
ip Enter the keyword
ip
to configure a generic IP access list.
The keyword
ip
specifies that the access list permits all IP
protocols.
tcp Enter the keyword
tcp
to configure a TCP access list filter.
udp Enter the keyword
udp
to configure a UDP access list filter.
source Enter an IP address in dotted decimal format of the network
from which the packet was received.
mask (OPTIONAL) Enter a network mask in /prefix format (/x) or
A.B.C.D. The mask, when specified in A.B.C.D format, may be
either contiguous or non-contiguous.
any Enter the keyword
any
to specify that all routes are subject
to the filter.
host ip-address Enter the keyword
host
and then enter the IP address to
specify a host IP address or hostname.
Access Control Lists (ACL)
243