Dell Networking S4810, Справочное руководство

Страница: 1384 / 1761

To stop marking packets, use the
no wred ecn
command.
Defaults none
Command
Modes CONFIGURATION (conf-qos-policy-out)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820t.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Usage
Information
When you enable
wred ecn
, and the number of packets in the queue is below the
minimum threshold, packets are transmitted per the usual WRED treatment.
When you enable
wred ecn
, and the number of packets in the queue is between
the minimum threshold and the maximum threshold, one of the following three
scenarios can occur:
• If the transmission endpoints are ECN-capable and traffic is congested, and the
WRED algorithm determines that the packet should have been dropped based
on the drop probability, the packet is transmitted and marked so the routers
know the system is congested and can slow transmission rates.
• If neither endpoint is ECN-capable, the packet may be dropped based on the
WRED drop probability. This behavior is the identical treatment that a packet
receives when WRED is enabled without ECN configured on the router.
When you enable
wred ecn
, and the number of packets in the queue is above the
maximum threshold, packets are dropped based on the drop probability. This
behavior is the identical treatment a packet receives when WRED is enabled
without ECN configured on the router.
Related
Commands
wred-profile — creates a WRED profile and name that profile.
wred-profile
Create a WRED profile and name the profile.
S4810
Syntax
wred-profile wred-profile-name
To remove an existing WRED profile, use the
no wred-profile
command.
1384
Quality of Service (QoS)