Dell Networking S4810, Справочное руководство

Страница: 1569 / 1761

Version 9.1(0.0) Added support for config and ecmp traps.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.4.1.0 Added support for VRRP traps.
Version 7.6.1.0 Added support for STP and xSTP notification types.
Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
In order to configure the router to send SNMP notifications, enter at least
one
snmp-server host
command. If you enter the command with no keywords, all
trap types are enabled for the host. If you do not enter an
snmp-server host
command, no notifications are sent.
In order to enable multiple hosts, issue a separate
snmp-server host
command
for each host. You can specify multiple notification types in the command for each
host.
When multiple
snmp-server host
commands are given for the same host and
type of notification (trap or inform), each succeeding command overwrites the
previous command. Only the last
snmp-server host
command will be in effect.
For example, if you enter an
snmp-server host inform
command for a host
and then enter another
snmp-server host inform
command for the same
host, the second command replaces the first command.
The
snmp-server host
command is used with the
snmp-server enable
command. Use the
snmp-server enable
command to specify which SNMP
notifications are sent globally. For a host to receive most notifications, at least one
snmp-server enable
command and the
snmp-server host
command for that
host must be enabled.
NOTE: For v1 / v2c trap configuration, if the community-string is not defined
using the
snmp-server community
command prior to using this command,
the default form of the
snmp-server community
command automatically is
configured with the community-name the same as specified in the
snmp-
server host
command.
Configuring Informs
To send an inform, use the following steps:
1. Configure a remote engine ID.
2. Configure a remote user.
3. Configure a group for this user with access rights.
Simple Network Management Protocol (SNMP) and Syslog
1569