Dell Networking S4810, Справочное руководство

Страница: 936 / 1761

• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
• For a tunnel interface, enter the keyword
tunnel
then
the tunnel interface number. The range is from 1 to
16383.
• For a VLAN interface, enter the keyword
VLAN
then the
vlan number. The range is from 1 to 4094.
If you configure a static IPv6 route using an egress interface
and enter the
ping
command to reach the destination IPv6
address, the ping operation may not work. Configure the
IPv6 route using a next-hop IPv6 address in order for the
ping
command to detect the destination address.
ipv6-address (OPTIONAL) Enter the forwarding router IPv6 address in the
x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
distance (OPTIONAL) Enter a number as the metric distance assigned
to the route. The range is from 1 to 255.
tag value (OPTIONAL) Enter the keyword
tag
then a tag value number.
The range is from 1 to 4294967295.
permanent (OPTIONAL) Enter the keyword
permanent
to specify that
the route is not to be removed, even if the interface assigned
to that route goes down.
NOTE: If you disable the interface with an IPv6 address
associated with the keyword
permanent
, the route
disappears from the routing table.
Defaults none
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.0.0 Introduced on the Z9000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
936
IPv6 Basics