Dell Networking S4810, Справочное руководство

Страница: 542 / 1761

dcb-policy output stack-unit stack-ports all
Apply the specified DCB output policy on all ports of the switch stack or a single stacked switch.
S4810
Syntax
dcb-policy output stack-unit {all | stack-unit-id } stack-ports
all dcb-output-policy-name
To remove all DCB output policies applied to the stacked ports, use the
no dcb-
policy output stack-unit all
command.
To remove only the DCB output policies applied to the specified switch, use the
no
dcb-policy output stack-unit
command.
Parameters
stack-unit-id Enter the stack unit identification.
dcb-output-
policyname Enter the policy name for the DCB output policy.
Defaults none
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0 Introduced on the S4820T.
Version
8.3.12.0 Introduced on the S4810.
Version
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
NOTE: Please note that Dell Networking does not recommended to use this
command as it has been deprecated in the current 9.4.(0.0) release. A warning
message appears when you try to run this command indicating that you have
to use the dcb-map commands in the future.
The
dcb-policy output stack-unit all
command overwrites any previous
dcb-policy output stack-unit stack-unit-id
configurations. Similarly, a
dcb-policy output stack-unit stack-unit-id
command overwrites any
previous
dcb-policy output stack-unit all
configuration.
You can apply a DCB output policy with ETS configuration to all stacked ports in a
switch stack or an individual stacked switch. You can apply different DCB output
policies to different stack units.
542
Data Center Bridging (DCB)