BRP Outlander 400 EFI 2008, Руководство по обслуживанию

Страница: 93 / 434

Section 03 ENGINE
Subsection 07 (MAGNETO/STARTER)
vmr2008-139-009_b
STARTER VOLTAGE TEST
If you do not obtain close to battery voltage at the
starter terminal, carry out a continuity test of the
wire between the starter and the solenoid.
If you obtained close to battery voltage at the
starter terminal and the starter does not rotate,
try a pull start to see if the engine is mechanically
locked.
If engine rotates freely on a pull start, replace the
starter.
Starter Cable Continuity Test
Carry out a continuity test of the starter cable as
per following table.
NOTE: An abnormally high resistance may be at-
tributable to loose, dirty, or corroded connections.
STARTER CABLE CONTINUITY TEST
RED PROBE BLACK PROBE MEASUREMENT
Starter
terminal
Solenoid starter
terminal
Close to 0
(continuity)
vmr2008-139-009_c
STARTER CABLE CONTINUITY TEST
Clean, repair, or replace wiring and connections
between starter and solenoid as required.
Starter Removal
Make sure the ignition switch is in the OFF posi-
tion.
Disconnect the BLACK (-) battery cable from the
battery.
vmr2008-138-004_b

WARNING
Always disconnect BLACK (-) battery cable
first and reconnect last.
Remove the RH side cover, refer to the
BODY
section.
Remove the radiator coolant hose support by re-
moving the two mounting screws.
vmr2008-139-011_a
1. Radiator coolant hose
2. Hose support
3. Remove support screws
Disconnect the RED (+) power cable from starter.
88
vmr2008-126