BRP Outlander 400 EFI 2008, Руководство по обслуживанию

Страница: 16 / 434

Section 01 MAINTENANCE
Subsection 03 (STORAGE PROCEDURE)
Inspect and clean pulleys then spray XP-S Lube
(P/N 293 600 016) on pulley faces.
Do not reinstall drive belt. Close CVT cover.
ELECTRICAL SYSTEM
Battery Removal and Storage
Remove the battery. Store it in dry and cool place
out of the sun, refer to
BATTERY in CHARGING
SYSTEM section.
VEHICLE
Vehicle Cleaning
To facilitate the inspection and ensure adequate
lubrication of components, it is recommended to
clean the entire vehicle.
Wash and dry the vehicle.
CAUTION: Never use a high pressure washer
to clean the vehicle. USE LOW PRESSURE ON-
LY (like a garden hose). The high pressure can
cause electrical or mechanical damages.
Remove any dirt or rust.
To clean the vinyl or plastic parts, use only flannel
clothes with Vinyl & Plastic Cleaner (P/N 413 711
200).
CAUTION: It is necessary to use flannel cloths
on plastic parts to avoid damaging surfaces.
Never clean plastic parts with strong detergent,
degreasing agent, paint thinner, acetone, prod-
ucts containing chlorine, etc.
To clean the entire vehicle, including metallic parts
use BRP heavy duty cleaner (P/N 293 110 001).
Inspect the vehicle and repair any damage. Touch
up all metal spots where paint has been scratched
off. Spray all metal parts with XP-S Lube (P/N 293
600 016).
Vehicle Protection
To prevent the intrusion of small animals or oth-
er debris, block the following locations with clean
rags:
– CVT air inlet duct
– CVT air outlet duct
– Air intake inlet
– Muffler.
CAUTION: Do not forget, these rags must be
removed during preseason preparation before
starting the vehicle.
To reach the CVT air inlet duct and the air intake
inlet, lift the console. Refer to
BODY
.
vmr2008-116-001_a
1. Console
vmr2008-116-002_a
1. CVT inlet hose
2. Air intake inlet
The CVT outlet hose is located at the rear of en-
gine, against vertical frame beam. The removal of
the left side panel is necessary to reach the hose.
vmr2008-116-003_a
1. CVT outlet hose
2. CVT cover
Protect the vehicle with a cover to prevent dust
accumulation during storage.
CAUTION: The vehicle has to be stored in a
cool and dry place and covered with an opaque
tarpaulin. This will prevent sun rays and grime
from affecting plastic components and vehicle
finish.
8
vmr2008-116