BRP Outlander 400 EFI 2008, Руководство по обслуживанию

Страница: 342 / 434

Section 07 DRIVE SYSTEM
Subsection 03 (REAR DRIVE)
vmr2008-143-011_a
1. Aluminum tube
2. Inner race
NOTE: In some case, you may have to hit one
side, then move the drive shaft 180 degrees in the
vise and hit the other side until joint is off.
Remove boot from drive shaft.
Check bearing in plunging joint or CV joint. If bear-
ing is hard to move, change plunging joint or CV
joint.
Check circlip for damage, change as necessary.
Drive Shaft Assembly
Insert the small clamp and the small end of boot
on shaft.
With the circlip in place, align the inner race
squarely with the shaft splines.
Using a plastic hammer, hit the end of the joint.
The joint should slip over the shaft until it bottom
out.
vmr2008-143-012
vmr2008-143-013
CV JOINT PROPERLY SEATED
vmr2008-143-014
PLUNGING JOINT PROPERLY SEATED
If the joint doesn't slide on, there is a good chance
that the circlip came out of its groove. Check and
try again with a new circlip.
vmr2008-143-015_a
1. Circlip out of groove
Pack bearing area with grease included in the new
boot kit.
NOTE: Do not use any other grease.
Fit the boot in place and install the clamps on the
boot using the CV boot clamp pliers (P/N 529 036
120).
smr2008-143
345