BRP Outlander 400 EFI 2008, Руководство по обслуживанию

Страница: 261 / 434

Section 06 ELECTRICAL SYSTEM
Subsection 01 (IGNITION SYSTEM)
1
V07G1BA
TYPICAL
1. Disconnect ignition switch connector
While holding switch with one hand, unscrew the
ignition switch retaining nut with the other.
vmr2008-137-002_b
TYPICAL
1. Remove retaining nut
Ignition Switch Installation
For installation of the ignition switch, reverse the
removal procedure.
Torque the switch retaining nut to 4 N•m
(35 lbf•
in ).
ENGINE STOP SWITCH
Engine Stop Switch Operation
The engine stop switch functions as an engine
shutoff switch for a normal shutdown or for an
emergency situation. It can be quickly activated
without letting go of the handlebars.
vmo2006-016-001_e
1. Engine stop switch button
2. STOP position
3. RUN position
When the engine stop switch is set to RUN, it
completes a circuit between the ignition switch
and the ECM. This circuit provides the 12 Vdc
power used to initialize the ECM.
If the engine is running and the engine stop switch
is set to OFF, the ignition will cease immediately,
the engine will shut down, but the ECM will main-
tain power on the vehicle for 30 seconds.
When the switch is set to STOP, it opens the
12 Vdc circuit to pin “A4” of the ECM and applies
a ground to pin “K3”.
If the engine stop switch is left in the STOP po-
sition when the ignition switch is turned to ON,
the ECM will not be initialized, the multifunction
gauge and tail light will not turn ON.
Engine Stop Switch Continuity Test
Remove the front steering cover, refer to the
BODY
section.
Disconnect the multifunction switch connectors,
MG1 and MG2.
260
vmr2008-137