BRP Outlander 400 EFI 2008, Руководство по обслуживанию

Страница: 368 / 434

Section 08 CHASSIS
Subsection 03 (FRONT SUSPENSION)
vbs2006-004-006
The bottom extremity cannot be locked in place;
simply sit the bottom of strut as shown.
vbs2006-004-008
Install the spring compressor pins to retain the
strut spring.
Tighten the spring remover screw until the spring
is sufficiently compressed to remove spring lock-
ing devices.
Remove spring stopper and its cap then loosen
the spring remover screw.
vmr2006-026-011
Strut Inspection
Inspect the spring for damage. Replace if neces-
sary.
Inspect strut as following:
Examine the strut for leaks.
Extend and compress the strut shaft several
times over its entire stroke.
Check that the strut shaft moves smoothly and
with uniform resistance with rod up.
Any of the following conditions will denote a de-
fective strut:
– A skip or hang up when reversing stroke at mid
travel.
– Seizing or binding conditions except at extreme
end of either stroke.
– A gurgling noise after completing one full com-
pression and extension stroke.
Replace strut if any of these conditions are found.
Strut Assembly
For assembly, reverse the disassembly proce-
dures.
Strut Installation
For installation, reverse the removal procedures.
However, pay attention to the following.
Apply Loctite 243 (blue) (P/N 293 800 060) on
threads of strut nut.
Tighten strut nut to 55 N•m (41 lbf•ft).
Install circlip. If the circlip appears loose, replace
it with a new one.
Install all other removed parts.
SUSPENSION ARM PROTECTOR
Protector Inspection
Check protector for cracks or other damages. Re-
place if necessary.
Protector Removal
Remove bolts then the protector.
372
vmr2008-146