BRP Outlander 400 EFI 2008, Руководство по обслуживанию

Страница: 104 / 434

Section 03 ENGINE
Subsection 08 (CONTINUOUSLY VARIABLE TRANSMISSION (CVT))
vmr2006-021-019_b
1. Lock nut
2. Centrifugal lever pivot bolt
3. Centrifugal lever
4. Thrust washers
5. Contact surface to the roller
CAUTION: Whenever replacing centrifugal
levers, always replace all levers at the same
time. Otherwise, the drive pulley will be un-
balanced (because of lever differences).
Slider Shoe
Check slider shoes for visible wear and replace if
damaged.
NOTE: If necessary, use a screwdriver to remove
slider shoes.
1
R400motr171A
1. Slider shoe
Sliding Sheave
Check sliding sheave no. 1 for cracks and sliding
contact surface for excessive wear. Replace slid-
ing sheave if necessary.
Measure centrifugal lever pivot bolt bores. Re-
place sliding sheave if bores are out of specifica-
tion or damaged.
A
R400motr172A
A. Centrifugal lever pivot bolt bore diameter
CENTRIFUGAL LEVER PIVOT BORE DIAMETER
NOMINAL
6.113 to 6.171 mm
(.241 to .243 in)
SERVICE LIMIT
6.300 mm (.248 in)
Measure bushing diameters of sliding sheave.
Use a dial bore gauge to measure bushing diame-
ter. Measuring point must be at least 5 mm (1/4 in)
from bushing edge.
R400motr173A
1
A
1. Bushing on fixed sheave side
A. Bore diameter of bushing
SLIDING SHEAVE LARGE BUSHING
NOMINAL
55.000 to 55.040 mm
(2.165 to 2.167 in)
SERVICE LIMIT 55.200 mm (2.173 in)
100
vmr2008-127